如何修改FLEX刀箱中以太网交换模块的CLI方式为：iscli或ibmnos-cli-联想知识库

联想服务 Think服务大客户服务联想官网

如何修改FLEX刀箱中以太网交换模块的CLI方式为：iscli或ibmnos-cli

2016-09-27知识编号：151798

催更新

知识点分析:

ibmnos-cli：一种老式的菜单命令行

iscli：大致 90% 以上的命令与 Cisco的相同或相似

以下操作请在未进行过配置的机器中操作。

操作步骤:

1、从ibmnos-cli模式进入到iscli模式

>> Main# boot

--------------------

[Boot Options Menu]

sched - Scheduled Switch Reset Menu

image - Select software image to use on next boot

conf - Select config block to use on next boot

netboot - NetBoot and NetConfig menu

mode - Select CLI mode to use on next boot

prompt - Prompt for selectable CLI mode

gtimg - Download new software image via SFTP/FTP/TFTP

ptimg - Upload selected software image via SFTP/FTP/TFTP

reset - Reset switch [WARNING: Restarts Spanning Tree]

cur - Display current boot options

>> Boot Options# mode

Currently set to use switch mode "ibmnos-cli" on next boot.

Specify new mode to use ["ibmnos-cli"/"iscli"]: iscli

Next boot will use mode "iscli".

重启交换机

Boot Options# reset

WARNING: There are unsaved configuration changes.

Confirm operation without saving changes (leave them pending) [y/n]: y

Reset will use software "image1" and the factory default config block.

>> Note that this will RESTART the Spanning Tree,

>> which will likely cause an interruption in network service.

Confirm reset [y/n]: y

Resetting at 2:28:11 Fri Aug 26, 2016...

2、从iscli模式进入到ibmnos-cli模式

Router>enable

Router#configure terminal

Router(config)#boot cli-mode ibmnos-cli

Next boot will use mode "ibmnos-cli".

Router(config)#reload

WARNING: The running-config is different to startup-config.

Confirm operation without saving running-config to startup-config (y/n) ? y

Reset will use software "image1" and the factory default config block.

>> Note that this will RESTART the Spanning Tree,

>> which will likely cause an interruption in network service.

Confirm reload (y/n) ? y